All the way around. I’m happy to report that I just got back from the range with promising results. If you try this, you’ll be reassured that it isn’t a linear reaction, meaning 24 hours at 80 degrees doesn’t mean 12 hours at degrees. Either buy the Golfsmith “Lie Board” or get a thin piece of plywood or masonite. Started by Barto78 , May 02 I will assume you are doing a standard reshaft 3-PW. If you take a small batch of 24 hour epoxy and sit in on the dash of your car on a hot day, it will set up completely in less than 30 minutes.
|Date Added:||15 March 2011|
|File Size:||58.92 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
How long after reshafting before hitting driver?
How long should you really wait for epoxy to cure Started by b. When the clubhead cools a bit, clean it out with the hosel wire brush.
I normally let in set overnight for use the next morning approx. You must log in or sign up to reply here. Has anyone done this before? There are 50 kinds of steel regular flex shafts so I dont even know where to begin getting an affordable fitting so I can order shafts. This works out to around 16 hours or so.
How long should you really wait for epoxy to cure
If you guys were in my shoes what would you do?? By zhangtony in forum Instruction Replies: Put some masking tape around the shaft past the end of the tool. I just had my old ones gripped with the green lampkin and I hate them already.
Many club builders use heating equipment to speed the cure. I will now describe the process if you were to do 1 shaft. Remove your finger over the big hole to make it come out faster. Mind where the NBP and S lines are if you spine-aligned. What I use in feshaft shop for a reshaft: What are some of your guys opinion on this matter?
How hard is it to reshaft clubs? |
As you can see, you would cut 2″ off the tip of your 5-iron. Want to hide this feshaft How long do you need to let shafts sit after a reshaft? My right thumb has already worn off the rubber after a couple weeks of playing. Search Advanced Search section: Slight fade from left to right but it was so much more controllable and consistent with my distances.
Aug 26, Messages: Posted 12 September – lkng Share This Page Tweet.
Both the clear and the dark need to come out semi-equally. Registration is fast, simple and absolutely free. Grip tape, grips, and grip solvent for the gripping process alternatives exist, but 2 sided grip tape and solvent are easy to work with. Grab a piece kong cardboard and 2 sticks for mixing.
Humidity, temperature, and the mix make all the difference in the world. I think Im going to try some kind of cord next time because they dont wear down fast.
How long do you need to let shafts sit after a reshaft?
Registering is free and easy! I would have to say that sounds about right because I played well with my old rifle shafts that were supposively just over a R flex.
I can do it-anyone can do it.